1. Computer

Check and kill viruses regularly, but be careful not to open the anti-virus level when working, and be careful of interference. Regularly clean the dust of the chassis, pay attention to the heat dissipation of the chassis, and be careful that too much dust may cause errors in the industrial control card. Regularly defragment the disk and optimize the computer system.

Computer abnormality will also cause many problems, especially for the computer connected to the engraving machine. In the process of maintaining the woodworking engraving machine, Ruichuang Intelligent Factory found that the computer abnormality also caused a lot of unnecessary trouble to our maintenance, and also delayed the customer's business. The Chuang Intelligent Technology Department summed up and proposed that customers pay attention to several aspects of computer maintenance.

2. Clean up

Regularly clean the industrial control box, dust is the biggest killer of circuit boards. Regularly clean the lead screw to prevent foreign objects from sticking to the lead screw. The lead screw is very important in the equipment. It determines the accuracy of the machine, and the lead screw also plays an important role in the transmission process.

After the work is finished, the countertop should be cleaned in time, which provides convenience for the next work of the woodworking engraving machine. Clean the guide rails and the material chips beside the guide rails to prevent the machine from jamming during the working process due to the interference of the chips.

3. Oiling

After adding oil, move back and forth at a slow speed to ensure that the lubricating oil can be evenly added to the guide rail and the lead screw. If the machine is not used for a long time, it should be regularly refueled and empty to ensure the flexibility of the transmission system.

First clean up the guide rail and lead screw, and use a cloth to remove the oil and material chips on the guide rail and lead screw without depilating. Due to the low temperature, oil can be added to both the guide rail and the lead screw, preferably antifreeze oil. The refueling cycle is twice a month, that is, once every two weeks.

4. Temperature

When the machine is not in use, if the room temperature is low, it is best to pour out the water in the water tank to prevent the water tank and water pipes from freezing. To ensure the ambient temperature of the operating room, the woodworking engraving machine is best to reach room temperature, at least the staff will not be very cold. Check the applicable temperature of the fueling standard, at least the minimum temperature.

The temperature has little effect on the woodworking engraving machine, but because the user added butter to the screw and forgot to clean it in winter, it would not work every time it was turned on, and the temperature in some studios was very low. On, the machine can't run.

5. Cooling water

Conditional can use antifreeze cooling. Pay attention to the ambient temperature, and be careful not to freeze the water tank and the water pipe due to the over-cold water temperature. Cooling water is a necessary condition for the normal operation of the spindle motor. If the cooling water is too dirty, it will cause serious damage to the motor. Ensure the cleanliness of the cooling water and the normal operation of the water pump. Pay attention to the water level, and never cause the water-cooled spindle motor to be short of water, so that the motor heat cannot be exported in time.